Search
Now showing items 1-10 of 31
Assessment of Lumen Degradation and Remaining Life of Light Emitting Diodes Using Physics Based Indicators and Particle Filter
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The development of lightemitting diode (LED) technology has resulted in widespread solid state lighting (SSL) use in consumer and industrial applications. Previous researchers have shown that LEDs from the same manufacturer ...
Bivariate Module Phase Synchronization of a Fractional Order Lorenz System in Different Dimensions
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Based on the classic Lorenz system, this paper studies the problem of bivariate modulephase synchronizations in a fractionalorder Lorenz system, bivariate modulephase synchronizations in a fractionalorder spatiotemporal ...
Assessing the Seismic Resilience of Power Grid Systems Considering the Component Deterioration and Correlation
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Electricity transmission systems are essential to a community's functionalities but are susceptible to the aggressive environmental or operational factors such as the natural hazards and the environment-induced component ...
A Deep Study on a Particle-Water Coupled Fast Induction Heating System
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A particle induction heating method to promote electrical heating performance for water is studied in this paper. The method sinks metal particles (we chose Nickel particles) inside water, and uses a radio frequency (RF) ...
Effect of Dehydroxylation on Tribological Performances of Synthetic Magnesium Silicate Hydroxide as Lubricant Additive
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The heat-treated nanoparticle heat-treated magnesium silicate hydroxide (MSHH) was obtained based on the synthesis of lamellar nanoparticle magnesium silicate hydroxide (MSH) and analysis of thermal stability, and the ...
Scheduling of a Single Flow Shop for Minimal Energy Cost Under Real-Time Electricity Pricing
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A time-indexed integer programing approach is developed to optimize the manufacturing schedule of a factory for minimal energy cost under real-time pricing (RTP) of electricity. The approach is demonstrated using a flow ...
Erosion Wear Characteristics of Tee Tubes With Gas–Solid Two-Phase Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Pressure manifold is prone to failure caused by cuttings and gravels included in the underground natural gas and shale gas. In particular, the tee tubes are one of the most easily failed components. In order to study the ...
Experimental Research on Heat Transfer Performance of CO2 Tube Bundle Falling Film Evaporator
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: CO2 is a promising refrigerant substitute, and falling film evaporator is widely used in high-capacity heat pump systems. In this article, a CO2 heat pump experimental device is built. According to experimental parameters, ...
Quantitative Assessment of Damage in Buried Polyethylene Pipe Subjected to Land Subsidence
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Traditional investigation of polyethylene pipe (PE) subjected to external loads focused only on the study of mechanical behavior or the failure judgment, but could not predict the damage evolution process. In this paper, ...
Gas–Solid Erosion Wear Characteristics of Elbow Pipe With Corrosion Defects
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Corrosion and erosion are the main factors of pipes failure. Erosion wear characteristics of elbow pipe with corrosion defect are investigated in this paper. Initially, the erosion result of nondefect elbow pipe is calculated ...